Skip to main content

Whoopee HD XL

  • Availability: In Stock
  • $23.95
  • Choose Options
    Please Select
  • Bookmark and Share

Designed for  Beta85x and Beta85x HD components and frame guards running on 2" props



1.5mm 3K full carbon fiber main frame

1mm 3K full carbon fiber top plate

TPU Printed Parts



3K Carbon Fiber frame

No Prop view

Supports Rakon Heli 40mm propeller guards or the Beta75x frame guards (not included, purchase separatly)

Uses knurled aluminum standoffs

Top or bottom mounted lipo battery

Tpu camera mount to reduce vibration

Support  16x16 , 20x20 and standard whoop FC

25mm stack height to fit most of your components with ease 

Designed to use the inexpensive  frame guards from the Beta85c 



1.5mm 3K carbon fiber bottom plate

1mm 3K carbon fiber top plate

Size: 95mm MTM 

Nylon Stansdoffs with metal screws

Flexible TPU 3D printed parts

Supported 16x16 ,20x20 and Whoop size FC

Top plate have a 20x20 hole pattern for mounting the Runcam split mini2  or Caddx Turtle

Motor hole dimension: 9mm  & 6.6mm 


Included in the kit:

1pc. CF bottom plate

1pc. CF top plate

Set of mounting hardware

2pc 3D printed camera mount

1pc 3D Printed antenna mount

1pc 3D printed battery strap


Recommended parts:

Beta85x,  Mobula7 standard and HD  

1103 motors  or the Beta85x 1105 6,000KV (9mm bolt pattern M2)

2" Beta85x props. or similar

Runcam Split Mini 2 or Caddx Turtle for HD or EOS1/2 for non HD build 

Micro VTX 25~200mw

Any micro receiver RX or your choice

300~450mah 2S lipo battery


Build Notes:

-Remember that this is not a direct conversion kit for your Beta85x. This frame supports 20x20, 16x16  and 36x36  so you can use a wide variety of stack , use the one you think that would  work best for your build. The recommended build is just a guidline. 

-Following the recommended build will saves you a lot of headache avoiding  the hassle of sourcing for parts thats can be hard to find.

-Keep your build as light as possible by using lighter components .Proper cable management is also very important to save on weight.

-If you are using a 16x16 or whoop fc stack you will need to mount the 20x20 Runcam Split Mini2 or Caddx Turtle on the top plate unless you are building a straight 20x20 stack

- Use the Beta85x  guards by cutting the into 2 pcs combinint 2 left and 2 right or you can also cut the guards individually and save up to a gram

-Remeber this is a cinematic quad meant for smooth slow HD recording , it was never meant to be as fast as your stock 75X or M7 its just not gonna happen as the weight on the HD camera alone is already at 13g. you can however make it more responsive and punchy by downgrading to a cmos non hd camera and removing the prop guards/duct .



Note: Pictures shown are for illustration purposes only and some are not  included with the kit, see product description for details. 



Write your comment
Enter the code in the box below: