Shipping in 7~10 days
Pre-order now and receive a free 4pcs Motor Guards!
3K Weave cut CF for a more rigid arms
Designed for the 65mm and 3" Props
Self adjusting lipo mount
Kit includes the stylish 3D printed Pod
Uses M2 metal screws and nuts
Supports 11xx and Amax 1103 motors
Stack mounting holes for 16x16 , 20x20 and Whoop stack ( recommended)
2mm cut along the weave carbon fiber frame
9mm tri's and quad M2 motor holes pattern (11xx)
26x26 Whoop Stack mount (also mounting holes for 16x16, 20x20)
M2 Metal screws and nuts
TPU printed pod and accessories
14x14 camera mount (EOS camera and similar)
What Comes with the kit:
1pc. CF main plate
4pcs. M2x12 screws
4pcs. M2x16 screws
4pcs. Metal luck nuts
1pc. Self adjusting lipo mount 350~450mah 2S
1pc. TPU Pod designed for EOS Camera
Will fit most whoop size flight controller like the GepRC 12A F4 , BetaFPV 12A, Mobula7
Motors: 1102, 1103, 1104, 1105, 1106 or any motors with 9mm m2 hole pattern
Camera: Runcam Nano2, Nano Racer, Caddx EOS2 or similar with a width of 14mm
VTX : TBS Unify Nano Pro, TBS Unify Nano Pro32 or similar
RX: Any micro RX for works with your radio trasmitter
Props: 65mm for lighter build with lower esc amp (5A) or 3" props on 12A or above.
Lipo: 350~450mah 2S using the incuded lipo holder or use 3S (needs rubberband or strap to hold the battery)
Highly recommended to use an XT-30 plug to reduce lipo sagging with high C rating
See it in action!
Reviews and flight
**Pod takes time to print specially if it has a custom stripes so please allow up to 2~3 days before shipping
**Will Ship only to confirmed paypal address so please make sure your paypal address is current before making a purchase.
Note: Picture shown are for illustration purposes only, electronics are not included . Please check product description.
Write your comment
Enter the code in the box below: