What are the features?
Uniquely designed frame with rear mounted camera provides better protection
Uses 2.5" props thats perfect for 11xx motors
Comes complete with TPU 3D printed accesories
Camera is fully tiltable up to 60 degrees
Slidable FC/ESC stack
29g. weight (includes titanium screws and aluminum standoffs)
What are the specifications?
2.5mm carbon fiber main plate
2.0mm carbon fiber top plate
2.0mm carbon fiber pod plates
Flexible TPU 3D printed parts
Titanium screws and anodized aluminum standoffs
What comes with the frame kit?
1pc. CF main plate
1pc. CF top plate
2pc. CF pod plates
4pc. Motor guard / softmout
1pc. 3D printed bumper accessory
2pc. FC/ESC stack spacer/softmount
Set of mounting hardwares
What parts do I need to build this?
20x20 4 in 1 ESC 12A or higher
20x20 F3/F4 Flight controller , M3 ~M2 will work
OR HGLRC Zeus AIO for a single board solution
11xx Brushless Motors
Runcam Swift Micro or similar
VTX02~03 Transmitter or similar
JST or XT30 plug
Micro Receiver RX
2S~3S high C rating 600mah+ lipo
Free to Download 3D Prints!
Note: Picture shown are for illustration purposes only, electronics are not included . Please check product description.
Write your comment
Enter the code in the box below: